Tektronix TEK P3420 Instruction free download

File name TEK P3420 Instruction.pdf

P3410 and P3420 Instructions Instructions P3410 Front Panel This package contains either a P3410 TTL pod or a P3420 variable pod. Twelve cables are supplied with each pod (012-1502-XX for the P3410 and 012-1504-XX for the P3420). Both pods are designed P3420 Front Panel to be used with the Tektronix DG2020 or DG2020A Data Generator. Refer to Figure 1 to determine which pod you are using. Information for installation, operations, specifications, and accessories can be found in the DG2020 or DG2020A User Manual. The following instruction describes about the cable connection only between the Pod and the DG2020A. However, if your data generator is the DG2020, you can also read this instruction as replacing Figure 1: P3410 and P3420 front panels DG2020A with DG2020. Pod Rear Panel Precaution for Connecting Cable Tab Slot DG2020A Rear Panel Yellow Index Mark CAUTION. Make sure that you have correctly inserted the cable plug in the DG2020A and the pod before turning on power. The yellow wire end of the connector must be aligned with the Yellow Index triangular yellow index mark on the DG2020A or pod. Mark Incorrectly connected cables will damage the DG2020A and the pod. To connect a cable between the DG2020A and a pod, align the yellow wire end of the cable connector Note that the connectors on the DG2020A rear panel are installed with the triangular yellow index mark on the with the tab slot down, and the connector on the pod rear panel is DG2020A or pod connector. Doing this also correctly installed with the tab slot up (see Figure 2). aligns the connector alignment tab. Then carefully but firmly insert the cable connector into the To connect a cable between the DG2020A and a pod, align the yellow DG2020A or pod connector. Tab wire end of the cable connector with the triangular yellow index mark on the DG2020A or pod connector. Doing this also correctly aligns the c